concrete02

Can a concrete garage floor be cleaned?

Can a concrete garage floor be cleaned? Don’t underestimate the power of warm, soapy water to keep your floors clean and remove minor stains. Mix about one-third cup powdered laundry detergent in a gallon of warm water, and scrub with a nylon-bristle brush. … Doing it a bit at a time makes it easy to keep your concrete garage floor clean.

How much rebar do I need for a concrete wall? That installed in house walls is usually 10 to 12 feet long, depending on the depth of footings. Most house walls use 1/2- or 5/8-inch rebar, but shorter walls and those that are not load-bearing sometimes are built with 3/8-inch; the smaller size is most often used in horizontal applications to match mortar joints.

How often do you put rebar in a block wall? Insert rebar in the footing when you pour it; this should be done at every three blocks or at intervals specified by your local codes.

Where is the rebar in a concrete wall? Slide the rebar locator horizontally over the concrete until it beeps. Guide the locator slowly along the edge of the concrete and pay attention to the display. Watch for a bar or circle appearing in the middle of the screen, which means you’re close to the rebar.

Can a concrete garage floor be cleaned? – Related Questions

How to polish concrete pots?

Polish the completed cement sculpture with fine sandpaper. Begin with approximately 200-grit and finish with 400-grit. After the sculpture is smooth, rub with dry talc, if desired, for additional polishing. Allow the concrete sculpture to cure for approximately seven days.

How to get water based paint off concrete?

Using a solution of methylated spirts, pour directly onto the paint spots and proceed to work it into the concrete by means of a long-handled brush. Metho works as a solvent to dissolve water-based paint, remember to work quickly as the metho will dry rapidly once its poured onto the concrete.

How much do concrete roof tiles weight?

Standard-weight concrete roof tiles generally weigh between 9.5 to 12 pounds per square foot (the roofing industry considers 1 square as a 10′ ft x 10 ft area on your roof)..

How much does labor cost to pour concrete?

A concrete slab costs between $4.34 and $7.73 per square foot, with an average cost of $6.60 per square foot. The national average cost of a concrete slab is $6.60 per square foot for materials and labor. Most homeowners can expect to pay between $4.34 and $7.73 per square foot for concrete installation.

How to fix concrete pitting?

Once the surface begins to pit, filling the divots with concrete is usually a temporary fix that loosens over time. You can fill pits with a bonding concrete repair material, which is similar to caulk. Restoring the porch to a more original appearance requires dressing it with a special resurfacing concrete mixture.

Is concrete a semi conductor?

With the right chemistry, cement can take on some of the properties of a metal, researchers report in the Proceedings of the National Academy of Sciences. Chris Benmore, a physicist at Argonne National Laboratory, explains why a semiconducting cement might be useful.

What kind of concrete to use for shower base?

The best concrete mix for shower pans is made by Quikrete. They make two products, the first is called Floor Mud, the 2nd is their Sand/Topping mix. Both work great for building a shower pan. Just like other types of concrete mix, there are DIY options.

How to dye a concrete floor?

We decided to patch these before dying the floor with a basic cement mix from your local hardware store.

When concrete forming what are cowbells used for?

These snap ties are only connected on one side of the wall form box. The cowbells hold the whalers, The hairpins hold the strongback.

Should concrete be under fence post?

Do Fence Posts Need To Be Set in Concrete? No, fence posts don’t need to be set in concrete, and there are plenty of other ways to fix your posts if this feels a bit too permanent. If you are using wooden posts, concrete may actually be the worst option.

How to get concrete fence posts out?

The most common way to get stubborn fence posts out of the ground is simply to dig the earth out from around the concrete base. It is possible to do this with nothing more than a standard shovel or spade and plenty of time.

How to make aerated concrete blocks?

The most common way to get stubborn fence posts out of the ground is simply to dig the earth out from around the concrete base. It is possible to do this with nothing more than a standard shovel or spade and plenty of time.

Can you install airstone on concrete wall?

AirStone applies easily to interior drywall, concrete, brick, and many other surfaces. When you are ready to start putting the stones on the wall, start at a corner if there is one. Apply the stones tightly together, stagger the seams, and cut pieces down with a hacksaw to make them fit, if necessary.

Can you put concrete floors in a mobile home?

In most cases, builders put the floors in modular homes before they deliver them to the building site. However, this doesn’t make sense with a concrete floor as it’s a heavy choice of flooring material and not ideal for transporting on a truck.

How to break up concrete fence post base?

Break the concrete footing into two or more sections, using a cold chisel and steel mallet. Drive the tip of the chisel into the seam between the base of the post and top of the concrete until the concrete breaks. Repeat this on the opposite side of the post.

How expensive is carved concrete?

Concrete Overlay Cost for Floors, Patios & More. A basic floor overlay runs from $3 to $7 per square foot, which is comparable to high-end carpet or tile. The price can increase to $20 or more per square foot depending on textures, embeds, saw cuts, or other design elements that are added to the design.

Why lay plastic under concrete?

The sand layer cannot dry downwards by vapor diffusion because of the plastic sheet—it is a vapor barrier after all. In fact that’s why we have it under the slab. We want a vapor barrier under the slab. ** We want to prevent water vapor from coming up from the ground into the concrete slab.

What kind of concrete to use in restaurants?

Here’s why polished concrete is excellent for establishments, such as fast food outlets, restaurants, and any space with commercial kitchens:

How to install pavers on concrete patio?

Lay the field pavers over concrete as you would on any paver patio. Scrape away the excess sand and cut off the excess landscape fabric with a utility knife. Glue down the last border patio blocks. Let the glue dry for a few hours before you tamp the field pavers and sweep sand across the patio to fill the joints.

How to remove screw anchors from concrete?

Usually, a screwdriver, pipe wrench, or vise grips can unthread the protruding bolt, leaving the female anchor flush with the concrete. If needed, a hammer can be used to knock the anchoring tube below the floor, and in some cases these tubes can simply be pulled out of the hole entirely.

How to clean blood from concrete?

Pour a small amount of hydrogen peroxide 3% (regular peroxide from the store) directly onto the stain and leave for about fifteen minutes. The peroxide will break down the blood stain, enabling you to mop it up with a clean paper towel. Repeat with the peroxide until all traces of blood are removed.

Leave a Comment

Your email address will not be published.