fireplace090

How deep is a gas fireplace?

How deep is a gas fireplace? Gas fireplaces can be anywhere from 20 inches to 60 inches, but the size of the gas fireplace you choose will ultimately depend on the area of the room and the height of the wall you plan to put it in.

How do you clean an unsealed stone hearth? If the stones on your fireplace aren’t sealed, you will have to use a hard bristle brush to remove any debris. Once you have removed all you can, you should wet the stones as much as possible. You can use a sponge to do this on the vertical stones.

What do you use to clean a fireplace hearth? Mix 6 tablespoons of TSP, 1 cup of bleach and 1 gallon of warm water into a plastic bucket. Wearing rubber gloves, dip your nylon brush into the bucket, and then use the solution to scrub the walls and floor of your fireplace until they’re clean. (Old fireplaces may contain stains you can’t remove.)

How do you clean a concrete stone fireplace? All you need to proceed is a mild liquid detergent and a soft, non-wire brush. Wet the stone first, then gently scrub smoke and soot marks. Rinse with clean water. It can take a day or two for your mantel to dry completely.

How deep is a gas fireplace? – Related Questions

Can led tv go above fireplace?

The short answer is – yes. However, to ensure your television isn’t damaged from the heat, care must be taken to ensure heat generated by the fireplace is redirected away from television. There are several ways to do this, such as installing a proper mantel and building an alcove for the television.

How do you design around an off center fireplace?

If the fireplace is at the far end of a room, with little space on one side, expand the wall on the opposite side. Hang artwork or floor décor in the small space, and place shelving, display cabinets or a television on an eye-level stand in the extension.

How do you seal up a fireplace?

You can seal off an unused fireplace by installing wood or light-gauge metal framing, insulation and drywall over the entire wall or opening. If you intend on using it in the future, install an insert constructed out of 2″ rigid foam board glued to MDF. Seal around the insert using neoprene backer rod insulation.

How to cure rutland fireplace mortar?

Start a low fire, keeping the temperature below 210°F, until mortar has dried thoroughly, then increase the heat for the final cure. Heat for 1-2 hours at 500°F. If crack or joint is more than 1/8″ deep, mortar must be layered. Allow 24 hours to cure between layers.

Can you mount a tv above a real fireplace?

In most cases, you should not install electronics above wood-burning stoves or gas fireplaces and inserts because they produce massive amounts of heat. That heat could severely damage your tv or other electronic devices.

Can you mount tv over real fireplace?

In most cases, you should not install electronics above wood-burning stoves or gas fireplaces and inserts because they produce massive amounts of heat. That heat could severely damage your tv or other electronic devices.

How much to build a fireplace uk?

The average cost to install a fireplace will depend on the type of fireplace you want to create and can range from £600 – £3,850. Installing a small pre-made fireplace unit will be quite a lot cheaper than the cost to build a large bespoke stone fireplace.

How far does gas fireplace vent?

Thanks for the gas fireplace vent clearance question Dwight; You’ll see in the table above that the vent needs to be at least 24 inches away from any vinyl surface.

Do gas fireplaces require a flue?

Ventless fireplaces fueled by gas or propane rely on indoor air for combustion, and they exhaust a low level of their combustion gases into the room in which they’re located. A chimney or flue isn’t necessary.

How to clean paint off cast iron fireplace?

Make sure no residue of any paint, dirt, or grime remains on the surface. The best option is to use a paint stripper, such as Nitromors, for the purpose. Use a nylon paintbrush to apply the paint stripper, and scrub it off with a wooden or plastic scraper.

How far should mantle be above fireplace?

Most housing codes and the National Fire Protection Agency (NFPA) state that the bottom of the mantel must be at least 12” away from the top of the fireplace box.

Can you paint the inside of a brick fireplace?

For brick or metal, you must use high-temperature paint for your topcoats if you intend to enjoy a fire in the fireplace. You can also use high-heat spray paint for grills, but be sure to check all manufacturer’s recommendations no matter what kind of paint your buy.

How to get a bird out of fireplace?

The easiest way to get the bird out is to shut he doors to your fireplace, but open the damper in order to allow the bird to drop down into your fireplace. If you do not have doors on your fireplace, you can create temporary doors by taping a sheet across the opening.

How much gas fireplace cost per hour?

The average price of natural gas in the US in 2020 was around $11 per thousand cubic feet 1, equating to about $1.06 per therm. That means that a 38,000 BTU gas fireplace costs approximately $0.40 an hour to run.

How do you remove bifold fireplace doors?

Open one set of bifold doors. Then push up on the spring clip of the top-notch. Then slide the top of the door outwards and remove the pin from the downside of the door. The pin may be placed in the pivot hole, so remove gently.

How to brighten fireplace brick?

Vinegar and Water. Vinegar is a slightly acidic mixture that is commonly used for cleaning bricks, stones and grouts. Use a spray bottle or sponge to apply a 50/50 mixture of vinegar and water to the fireplace. After it sits for a few minutes giving the acid a chance to work, scrub and sponge the fireplace clean.

Can i mount my tv above a fireplace?

The short answer is – yes. However, to ensure your television isn’t damaged from the heat, care must be taken to ensure heat generated by the fireplace is redirected away from television. There are several ways to do this, such as installing a proper mantel and building an alcove for the television.

Can i have a wood fire in my gas fireplace?

The answer to “Can you burn wood in a gas fireplace?” is a resounding NO! That is, if your setup is a true gas-only fireplace. In this type of installation, burning wood is extremely hazardous. With other kinds of gas fireplaces, you might be able to burn wood, but only under the right conditions.

How high above a fireplace should a mantle be?

Mantel Height: We recommend installing the mantel 4.5′ from the floor. This allows room for stockings during the holidays. Most housing codes and the National Fire Protection Agency (NFPA) state that the bottom of the mantel must be at least 12” away from the top of the fireplace box.

How to clean brass fireplace tools?

Dip the steel wool in vegetable oil and rub it gently on the surface. You may also dip it in hot water. After removing the grime, apply a polish to bring back the luster of your tools. To remove corrosion from brass tools, you can try the combination of lemon and salt or hot vinegar and salt.

Do you have to open damper on gas fireplace?

The damper in a gas fireplace should remain open all the time. The glass between the firebox and your home prevents cold or heat from coming down the chimney and by leaving the damper open at all times, you eliminate the risk of having gas build up or backdraft into your home.

Leave a Comment

Your email address will not be published.