concrete29

How do you treat a concrete fish pond?

How do you treat a concrete fish pond? Concrete ponds can be “cured” and made safe for fish without any special coatings. Keep the newly constructed pond filled for a week, then drain and refill. After two weeks, drain and refill again. After three weeks, drain and refill again.

How do you fertilize a concrete fish pond? A fertilizer platform positioned one foot under water can be used to hold granular fertilizer off the bottom. Pour fertilizer or place open or slitted bags on the platform. The fertilizer will slowly dissolve and be distributed by water currents. A platform measuring 45 square feet is adequate for a 5- to 10-acre pond.

How do you make concrete fish safe? Gently sweep any debris and algae towards your bottom drain a few times a week. If you do not have a bottom drain, use a pond vacuum to suck up all the debris after it settles post-sweep. Be careful with liners not to scrub too vigorously or else you may rip a hole!

How do you calculate concrete slump? Place the cone next to the mound of wet concrete and put the steel bar level on top of it, extending over the top of the mound. Immediately measure the distance between the bottom of the steel bar and the top of the concrete mound. The distance, measured to the nearest 1/4 inch is the concrete slump.

How do you treat a concrete fish pond? – Related Questions

How to remove carpet glue off concrete?

Boil enough water using a large pot for pouring on the stubborn glue. Then, pour the hot water on the patches of glue and leave the water to stay for about 2 minutes to soak and soften the adhesive. Use of hot water is worth tying as it is the cheapest means of removing glue from the floor surface.

How long does a concrete bridge last?

The average lifespan of a bridge ranges between 50-70 years. Many factors can influence that life span, however poor concrete practices and low-quality materials can cut those lifespans by decades.

Can you psint a concrete porch?

Concrete outdoor surfaces can face a lot of wear and tear over time, but a fresh coat of paint can provide a welcome makeover. The best concrete paint or stain conceals discolorations and signs of damage while providing a protective coating that extends the life of the surface.

What glue concrete together?

For smaller concrete gluing projects in and around the house, Loctite Extreme Glue Gel is the top choice. Its highly versatile formula contains Flextec technology which bonds quickly and allows for flexibility.

Can you stain concrete after it is poured?

On a new concrete slab, how long must you wait before you can acid stain it? -John. … The instructions with most acid stains (as well as concrete sealers and coatings) say to wait at least 28 days after pouring a slab before finishing it, with some recommending as long as 60 days.

What lengths does concrete tubes come in?

Size: Available in 6” (152 mm), 8” (203 mm), 10” (254 mm) and 12”(305 mm) diameters in 4′ (1.2 M), lengths. The amount of concrete required for each size tube is illustrated in Table 1.

How to seal cracks in concrete ceiling?

You will need an epoxy-based concrete repair compound, particularly one that bonds more slowly. After injecting the compound into the crack, smooth the surface with a putty knife. Do not be shy about adding more compound to the crack, as you need to be sure that the crack is being filled. Cover the repair as it cures.

Are concrete houses cheaper?

You will need an epoxy-based concrete repair compound, particularly one that bonds more slowly. After injecting the compound into the crack, smooth the surface with a putty knife. Do not be shy about adding more compound to the crack, as you need to be sure that the crack is being filled. Cover the repair as it cures.

How long does concrete pad need to dry before framing?

Generally, you can start framing on a poured concrete slab seven days after it is poured. Around this time period, the concrete slab will have reached 70% of its fully cured strength. This strength level is said to be adequate enough to support loads such as the framing for a house.

How long do forms need to stay on concrete?

The forms or “molding” that holds the concrete in place until it dries should be left alone for at least two days to ensure that the concrete is completely dry. If the forms are removed too soon, the concrete can begin to sag, crack and collapse, especially if conditions like temperature affected its strength.

Is a permit required for a concrete slab in backyard?

No, building permits are usually related to the dimensions of the finished patio or other external factors, such as whether you live in an environmental protection zone. As neither a concrete patio or deck would alter the house itself, they would usually not require a permit at all.

How to make concrete powder into concrete minecraft?

To turn it into concrete you’ll need to add an extra ingredient – water. As soon as a concrete powder block touches water, it’ll harden immediately into full concrete. Magic!

Can you repair pitted concrete?

Once the surface begins to pit, filling the divots with concrete is usually a temporary fix that loosens over time. You can fill pits with a bonding concrete repair material, which is similar to caulk. Restoring the porch to a more original appearance requires dressing it with a special resurfacing concrete mixture.

How to install composite decking on concrete slab?

For composite decking, many recommend using at least pressure-treated wood. The sleepers should at least be 1 1/2 inches in height and width. While you can follow the concrete slab’s slight slope, you can also use spacers to level it. Secure the sleepers in place by drilling them into the slab carefully.

Where can i watch dragged across concrete?

Dragged Across Concrete, a crime movie starring Mel Gibson, Vince Vaughn, and Tory Kittles is available to stream now. Watch it on HBO Max, Spectrum TV, The Roku Channel, Redbox., Prime Video, Apple TV, VUDU or Vudu Movie & TV Store on your Roku device.

Why repair concrete cracks?

When concrete cracks, water can get into the joints, freeze, and then expand to make the cracks even larger. Caulking is a great way to stop water from leaking underneath your concrete to prevent the cracks from causing a number of issues for your property, such as water damage and foundation problems.

Can you put concrete over tile countertops?

Concrete countertops are often the domain of professionals, but you can create a concrete overlay on an existing tiled countertop with a few humble supplies and materials. Set-in fixtures such as sinks and drop-in cook tops should be removed first.

What anchor should i use on concrete block?

Machine Screw Anchor – is best used in the solid section of a cinder block because it requires the bottom of the hole to be used for proper setting and expansion. The machine screw anchor needs to be set using a setting tool.

How do you kill mold on concrete?

The best solution is to scrub and clean the affected areas with a mold-killing detergent, like RMR-86 Instant Mold & Mildew Stain Remover, or a simple solution of household bleach and water. Be sure to scrub aggressively to get down into the pores of the concrete.

What’s more expensive asphalt or concrete?

The cost of an asphalt driveway is typically cheaper than concrete, costing $2.00 – $4.00 per square foot. … In contrast, a concrete driveway costs between $4.00 – $6.00 per square foot for a standard installation. Finishes, details and stains can increase the price tag to as much as $15.00 per square foot.

Leave a Comment

Your email address will not be published.