curtain24

How to make a rain poncho from a shower curtain?

How to make a rain poncho from a shower curtain? Take out the body section and cut a 2-inch slit in the middle of one side of the head hole. Fold the flaps under and pin them down to make the front neck opening of the poncho. Pin the hood inside of the hole. It helps to carefully try it on a couple times and make sure it lays right.

Can you make a raincoat out of a shower curtain? Fold the shower curtain in half with right sides facing & the fold at the top. … Snag that chopped shower curtain hook piece, cut to size & pin to one side of the front of the raincoat just below the neckline (right sides facing). Stitch together. W A R N I N G !

How do you make a rain poncho with a hood? Stitch up the sides and bottom on your sewing machine. Use the longest stitch length possible (on my machine that’s a 4), because each time the needle punctures your fabric it is perforating the seams. If you make the stitch length too short, the plastic could rip over time.

How often should you wash your shower curtain liner? After all, you come face to face with your shower curtain or plastic liner on an almost daily basis. Ideally, you should be washing it once a month. At the very least, however, you should aim to clean your plastic shower curtain once every three months.

How to make a rain poncho from a shower curtain? – Related Questions

How to soften stiff curtains?

Mix a small amount of laundry detergent with water and dip a clean rag into it. Rub this gently on a small corner on the back of the curtain where the face fabric folds over to form the hem. Rinse the corner with a few spritzes of water. If the color bleeds, do not use any further wet methods to soften the curtains.

How to remove odor from curtains?

All you would need to do is pour some diluted vodka in a spray bottle and apply it on the drapes. Then, give it a few minutes before the drapes dry up and you are good to go. Vodka helps eliminate bad odors from curtain smells, carpets, upholstery, and the likes. So this proves to be a cheap yet effective trick!

How to make plain curtains look fancy?

Transform plain curtain into a special handmade look with an embroidered ribbon. Choose a trim that is wide enough to complement the curtain length. You’ll want the color to stand out against the curtain color, so look for something significantly lighter or darker (or complementary) to the curtain.

How to hang backdrop curtains?

If your backdrop has grommets, you can hang the backdrop from the rod using hooks, as if it were a shower curtain. If it doesn’t have grommets, drape the backdrop over the rod as if it were a towel on a towel rack.

How to get mold off of bottom of shower curtain?

Spray a solution of two parts hydrogen peroxide and one part water onto the shower curtain. Let the hydrogen peroxide sit for five to ten minutes. Rinse thoroughly. Use a baking soda paste and scrub the mold until it’s gone.

How to loop curtains over a rod?

Drape them over their respective ends of the curtain rod, with the widthwise folds placed at the top of the rod. For a single swag, fold the curtain in half widthwise. Pass the folded end of the curtain behind the rod, and then pull it over the top of the rod. Pull the folded end down to your desired swag length.

Can i cut curtain rods?

Most hollow core metal drapery rods can be cut using a hacksaw with a fine cutting blade. Or, as long as you have a fine metal blade, you can use a powered miter saw. Make sure to buy metal curtain rods that are hollow core if you plan to cut them to size yourself.

How to wash shower curtain and liner?

Fill your washing machine with warm water on the largest load setting. Add a couple of drops of detergent and a cup of white vinegar. Toss in your cloth shower curtain on a gentle setting. Once the cycle is complete, hang your curtain back on the rod to air dry.

Do curtain rods have to match?

Curtain rods should “match” the fabric. Heavier drapes such as velvets work well on large and somewhat decorative rods while light silks and sheers can sit on light-weight, thinner bars. That said, hardware should also compliment the rest of the room, and it’s helpful to repeat a material or tie in a theme.

How to put up curtains with baseboard heaters?

When hanging curtains in front of baseboard heaters, the curtains should fall 1″ from the floor and hang 2-3″ from the edge of the heater.

How to clean white polyester curtains?

Every few months, machine-wash the panels in cold water on a gentle cycle. Use a mild laundry soap that’s free of brightening ingredients or bleach, which can affect the color of polyester fabric. For delicate or embellished panels, hand-washing is a safer alternative.

How to select curtain color?

For a pleasing look, choose drapes in a colour that complement the shade of your walls. Alternatively, if you want the curtain colours to be the focus, pick a hue that contrasts with the furniture and walls.

How to make a shower curtain rod shorter?

Place the coping saw blade directly on the marker line of the shower curtain rod. Keep the blade straight up and down to avoid making an angled cut. Place the blade end that is closest to your hand on the mark, and pull back on the saw to make your first cut. There will actually be a slight cut mark at this point.

How to measure for curtain rods?

To determine the optimal width of your curtain rod, you’ll need to measure the width of your window including the frame or trim. Take this measurement three times: once at the top, once at the center, and once near the bottom of your window. These measurements will most likely vary slightly.

How to measure for pre made curtains?

Most ready-made curtains come in these widths: 117cm (46”), 168cm (66”) or 228cm (90”). To work out which one you need, measure the length of the rail or pole (between the finials), not the window. This measurement is the width of each curtain and means they’ll have a lovely, full gather even when closed.

How to get rid of mould on a shower curtain?

Spray a solution of two parts hydrogen peroxide and one part water onto the shower curtain. Let the hydrogen peroxide sit for five to ten minutes. Rinse thoroughly. Use a baking soda paste and scrub the mold until it’s gone.

How to keep your shower curtain from molding?

By lowering the humidity in your bathroom, you can prevent mildew from developing on the shower curtain, bathtub and other surfaces.

How high do i hang a shower curtain rod?

A standard shower curtain is typically 72 inches long, so the curtain rod should be installed around 75 to 77 inches from the floor. This height will keep the shower curtain from touching the floor.

How to darken your curtains?

Once you buy your blackout fabric cut it to the right height, then simply lay it on top of your curtain, lining up the top and side edges… Then cut the side with the excess fabric… Then use your sewing machine to stitch along the top edge of your blackout fabric.

How long should shower curtain liner be?

A shower curtain liner should be as long as the shower curtain itself. Most shower curtain liners are 72 inches long — like curtains themselves — but can come in extra long sizes.

Leave a Comment

Your email address will not be published.