How deep is a standard fireplace? The standard size of a fireplace is anywhere from 2 – 3 feet wide, 24 – 29 inches high, and always about 16 inches deep. Of course, the opening could vary depending on your style and design ideas, as well as where you are locating the fireplace.
How deep is a regular fireplace? A fireplace’s depth is measured from the back of the firebox to the opening—the average depth of a fireplace is about 16 inches deep.
What is the size of a normal fireplace? An average fireplace is about 36”x30”. When it comes to the actual dimensions of a fireplace, these can be found in just about any size larger than 24”x24”, all the way up to 48”x32” and higher. The physical size of a fireplace insert is often listed by the width in inches, and they tend to range from about 20” to 60”.
How deep should a fireplace wall be? If the walls around the fireplace are protected by a heat-resistant material or some form of insulation, the fireplace can be less than 36 inches from the wall. However, a good rule of thumb is to leave at least 36 inches between the fireplace and the wall.
How deep is a standard fireplace? – Related Questions
How to remove tile from around fireplace?
Place the edge of your cold chisel under the edge of a piece of tile. Tap the hammer gently to move the tip further under the piece and wedge it up. Continue slowly tapping until you pop the piece of tile up. Work your way across the hearth tile by tile.
Do electric fireplaces give off any heat?
A handful of today’s electric fireplaces are just fake fireplaces and only for looks; they produce light but no heat. Most models, though, generate warmth in much the same way a space heater does. Some come with thermostats to maintain a steady temperature in the room, while others feature basic heat-level settings.
How much electricity does electric fireplace use no heat?
Electric fireplaces use only about 1,500 watts of electricity. Operational costs range between 0.003 to 3 cents per hour when you use them strictly for decorative purposes — that is, the flames are activated but no heat is produced.
Where is the hearth on a fireplace?
Clearing up the basics first, the hearth is, quite simply, the floor of a fireplace. In a traditional fireplace, the fire basket would be placed on top of the hearth below the chimney opening. They usually extend out into the room slightly and are made out of some sort of stone or brick.
Should you close glass doors on fireplace?
The doors should always be fully open or fully closed. Glass doors should be fully open when starting a fire and when the fire is burning strongly. The glass doors should be closed as the fire dies down to minimize the amount of room air going up the fireplace chimney.
How much does it cost to install a soapstone fireplace?
You can expect to pay between $2000 and $4500 for a cast iron wood stove that has soapstone.
Can you run a gas fireplace without electricity?
Yes! All Regency gas fireplaces, inserts, and stoves can operate safely during a power outage. The fireplace will continue to produce radiant heat and warm up the home. If your unit has a blower, it will no longer work; however, a fireplace blower is not necessary for the operation or safety of the fireplace.
How high should pilot light be on gas fireplace?
A proper pilot flame should be blue with a yellow tip and should be strong enough to cover about 1/2 inch at the end of the thermocouple tip. If the flame is too strong and improperly adjusted, it will be blue but may be noisy and lift off the thermocouple, causing improper furnace operation.
Does a gas fireplace require a chimney?
Ventless fireplaces fueled by gas or propane rely on indoor air for combustion, and they exhaust a low level of their combustion gases into the room in which they’re located. A chimney or flue isn’t necessary. … In fact, ventless fireplaces generally are just for aesthetics and supplemental space heating.
Do you close glass doors on fireplace?
The doors should always be fully open or fully closed. Glass doors should be fully open when starting a fire and when the fire is burning strongly. The glass doors should be closed as the fire dies down to minimize the amount of room air going up the fireplace chimney.
Do gel fuel fireplaces give off heat?
A single can of gel fuel typically provides about 3,000 Btus (British thermal units) of heat. … While gel fuel fireplaces create less heat than wood or gas, very little of the heat is lost because there is no chimney—and no draft pulling warm air from the room and out through the chimney.
What type of insulation to use around a fireplace?
Apply insulation (batt or spray foam) within the framing of the wall up to the ceiling or roof line. Install a thin structural sheathing material (e.g., drywall, rigid insulation, lightweight steel or aluminum sheeting). Bend the liner at the corners or seal seams with a bead of adhesive.
How to cover fireplace with drywall?
When attaching plasterboard to a brick fireplace wall, you have two options: use construction adhesive to glue the drywall directly to the brick, known as the direct bond method, or mount the drywall with screws. Both methods require you to cover the joints with tape and compound.
Do gel fuel fireplaces smell?
The gel fuel itself is odorless. You can smell the alcohol in the product when you pry off the lid, but that is the extent of the issue. When you light the canister to start the fire, you’ll get a faint smell of liquor from the fireplace with some fuels.
How often to service gas fireplace?
If you like a roaring fire from autumn all the way through spring, you should conduct or schedule service once a year, ideally early in the summer. If you only use your gas fireplace occasionally, you can probably get by with a fireplace service check every two years.
Can i rearrange logs in my gas fireplace?
The direction you lay them will depend on the design of the fireplace and the size of the logs. Leave 2 inches (5 centimeters) between logs. Make sure none of the logs is blocking the gas flow. If you find that a log is blocking it, you will have to re-arrange the logs.
Are fireplace doors efficient?
Fireplace glass doors are able to greatly increase the efficiency of the fireplace by acting as a barrier between your home and your chimney. … When left open in the winter, the fireplace will allow warm air to escape up and out the chimney and in the summer cool air conditioned air is able to escape from the chimney.
How much to install masonry fireplace and chimney?
Building a new masonry fireplace costs between $3,500 to $5,600 on average. The cost to install a prefabricated brick fireplace is $2,000 to $3,000, whereas an authentic mason-built brick fireplace can cost $10,000 or more.
How much would it cost to reface a fireplace?
Depending on the type of stone, refacing your fireplace averages $60 per square foot but could cost more than $100 per square foot. When refacing, a professional will either remove the existing fireplace or install the new material over it.
How to get a video of fireplace on your tv?
Plug USB with fireplace video on into your SMART TV and it will ask you if you want to watch the fireplace on your TV. Play the fire video on your TV and select the Repeat or Loop option so it plays continuously, looping every 20 minutes. Sit back, relax and enjoy the real fire screensaver on TV.
How to keep cold air from fireplace?
Along with the common throat damper located just above the firebox, some homeowners add a top-sealing damper at the top of the chimney to double their protection. Another great way to block cold air is with a chimney balloon or plug.