How to treat new concrete pond? Concrete ponds can be “cured” and made safe for fish without any special coatings. Keep the newly constructed pond filled for a week, then drain and refill. After two weeks, drain and refill again. After three weeks, drain and refill again.
How long does a concrete pond take to cure? Concrete fish ponds and ornamental pools are simple to construct but require initial treatment to stabilise them before the fish can be introduced. Treatment can consist of seasoning the pool by filling and emptying it two or three times over a period of a month or six weeks, or by treating it with chemicals.
Do you need to seal a concrete pond? However, concrete is a porous material and can eventually leach lime and other chemicals into your pond unless you seal the pond with a waterproofing compound. The market provides different products that provide a flexible, rubber-like, waterproof coating for your concrete pond.
How do you fertilize a concrete pond? A fertilizer platform positioned one foot under water can be used to hold granular fertilizer off the bottom. Pour fertilizer or place open or slitted bags on the platform. The fertilizer will slowly dissolve and be distributed by water currents. A platform measuring 45 square feet is adequate for a 5- to 10-acre pond.
How to treat new concrete pond? – Related Questions
What happens when you put a torch to concrete?
Concrete ponds can be “cured” and made safe for fish without any special coatings. Keep the newly constructed pond filled for a week, then drain and refill. After two weeks, drain and refill again. After three weeks, drain and refill again.
What does 6 bag mix mean in concrete?
A six bag mix is a concrete mix that has six bags of portland cement in it. In general, the more bags of cement in a mix, the stronger the mix. Most mixes have 5 to 7 bags of cement. Some concrete contractors (usually the old timers) will order their concrete based on bags rather than psi.
How to make high heat concrete?
Portion the materials into a 3:2:2:0.5 ratio so you have 3 parts gravel, 2 parts sand, 2 parts refractory cement and 0.5 parts of the hydrated lime. Follow this ratio regardless of the volume of fireproof concrete you will be making.
Can you float air entrained concrete?
Floating, brooming or another type of surface texture should always be used for exterior slabs. Also, do not trowel air-entrained concrete exposed to winter conditions and to deicing chemicals because troweling can seal and trap bleedwater and bleed air just below the top surface.
What are concrete masonry screws used for?
Masonry fixings are anchors used to fasten or attach an item to masonry. They can be used with various kinds of masonry including brick and blocks, as well as concrete.
What happens if you have too much water in concrete?
Lower compressive strengths. Segregation of the concrete mix under certain conditions resulting in variable quality throughout the concrete mass. Cracking – with too much water, there will be lower tensile strength, and a tendency towards high shrinkage and subsequent cracking.
How long does it take for concrete to go off?
Concrete typically takes 24 to 48 hours to dry enough for you to walk or drive on it. However, concrete drying is a continuous and fluid event, and usually reaches its full effective strength after about 28 days. Here are some of the basic facts regarding the question of concrete drying time.
How thick should i pour my concrete driveway?
As for thickness, non-reinforced pavement four inches thick is standard for passenger car driveways. For heavier vehicles, a thickness of five inches is recommended. To eliminate standing water, the driveway should be sloped towards the street a minimum of one percent, or 1/8 inch per foot, for proper drainage.
How many cf in a bag of concrete?
Regarding this, “how many cubic feet are in a bags of concrete?”, it’s depend on bag size and their weigh in pounds, generally each 60lb bag of concrete mix will yield approximately 0.45 cubic feet when mixed, thus there are 0.45 cubic feet in a bag of 60lb concrete.
How do i add color to concrete mix?
In a small container, mix the concrete coloring pigment with water, and then add to the concrete, according to the instructions on the bag. Tip: The more pigment you add, the more intense the color will be. Add a little more warm water than usual to the mix so it will pour easier into the bottle.
How can i make my own concrete?
In terms of the ratio for concrete, it depends on what strength you are trying to achieve, but as a general guide a standard concrete mix would be 1 part cement to 2 parts sand to 4 parts aggregates. For foundations, a mix of 1 part cement to 3 parts sand to 6 parts aggregates can be used.
How to remove pet stains from concrete?
First, clean spots with a two-to-one vinegar and water mixture, TSP or hydrogen peroxide and rinse off concrete. Next, apply and scrub in enzymatic cleaner to remove odor. Then, cover cement and let area sit and soak overnight for 12-24 hours.
How to screw into concrete ceiling?
Simply drill a hole into the concrete, hold the fixture you’re fastening over the hole, then use a hammer to tap the anchor into the hole. As you drive in the pin, the sleeve expands outward, trapping the anchor in the hole.
How do you get rid of mold on concrete?
The best solution is to scrub and clean the affected areas with a mold-killing detergent, like RMR-86 Instant Mold & Mildew Stain Remover, or a simple solution of household bleach and water. Be sure to scrub aggressively to get down into the pores of the concrete.
Can i lay plywood on concrete?
Plywood can easily adhere to concrete. Plywood is often used as a sub-flooring. It can be installed on top of concrete before hardwood flooring or another type of material is installed. One way to attach plywood to a concrete surface is to screw it into place with concrete fasteners.
Can you make your own concrete blocks?
Concrete bricks and blocks can easily be made at home with only a few items. Making your own concrete bricks and blocks can save you money if you are looking to build a small structure at home. You can even start your own small business producing these cost-effective building materials.
How much gravel below concrete slab?
You will need 3 inches of gravel under a concrete slab that is 4 inches thick. More gravel is better, but 3 inches is the minimum amount of gravel you should have with a 4” slab. Use ¾” washed and screened gravel, then compact it to level.
What will get rust stains off of concrete?
Simple dish soap should do the trick. After the surface is clean, start with pure lemon juice — not a diluted version, as the stronger the acid the better it will remove the stain. Once you’ve soaked the stain thoroughly with the lemon juice, let it sit. This is key.
How to fix settling concrete?
Three popular ways to repair settled concrete are to replace the concrete in its entirety, mudjack it or raise it using special polyurethane structural foam (often called Polyurethane Concrete Raising).
Is mop and glo good for concrete floors?
Waxing wax is used to act as a “sacrificial coating” that will take most of the abrasion and scuffing that could potentially damage your flooring. … Do not use cheap wax-cleanser combination products, such as Mop-n-Glo and other products available at your local grocery store.
Should i jump rope on concrete?
Concrete is the most commonly used surface for jumping rope. It is solid which allows you to easily push off from while its rough texture provides excellent grip and prevents slipping. You can jump the fastest on concrete because it allows for the best rebound.